SeaDoo Spark Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1 (Edited)
So I recently replaced the driveshaft because the teeth on the impeller end were worn out as well as the impeller. I replaced the impeller and wear ring with Solas stainless ones. The end going to the engine was fine and the coupler looked in good condition. I have a 2014 Spark 3up. The video attached is what happens when I try to start it. Any ideas?

There is a video I attached here.
 
1 - 5 of 5 Posts
Top