SeaDoo Spark Forum banner
1 - 2 of 2 Posts

· Registered
72 Posts
Discussion Starter · #1 ·
I purchased a tongue jack for my spark MOVE 1 trailer. When I installed it there was a lot of space underneath between the trailer tongue and the bottom bolts which causes the two small mounting brackets to bend at the bottom as I tightened everything up. The bracket that is attached to the swivel jack has a indentation that fits the size of my tongue perfect, just the bottom bolts are a little low. Any recommendations?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.