SeaDoo Spark Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I'm wanting to add the front storage bin.

The instructions say to drill the holes for the screws to go in. I have the drillbit but...

Does anyone know how deep to go? Is there any type of sealant needed since you're drilling directly into the plastic? The whole thing seems a bit sketchy.
 

·
Registered
Joined
·
78 Posts
that's what I thought, no sealant what I did was drill a little bit in with drill bit, than I drilled the screw in so it can be a tight fit, don't overdo it you will be fine!
 
  • Like
Reactions: serpent710
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top