Anyone have any recommendation for certain dock bumpers to protect the Spark?

I use the ones made by brp for the spark. They just snap in. So far they work great.

They look big and bulky, do they take up allot of room?

I can fit those, 30ft of rope, a small dry box and an extra vest in my front storage. If that gives you an idea

I use them as well. I store them in the rear cargo bag for the Spark. They fit perfectly in there. They worked really well when I was tied up along side a boat in calm water, but were terrible when I was docking in choppy water. They popped right out. The Sparks sit really low compared to other PWC's. The type of walls on the dock are going to play a big factor.

Xtreme-Spark said:

I can fit those, 30ft of rope, a small dry box and an extra vest in my front storage. If that gives you an idea

Click to expand...

good to know, it gives me a good idea.

We have the snap on fenders as well, and they are actually pretty small and fit great in the front storage. We used them to dock up at a restaurant and had no issues.

+1 for the pool noodle. They are so cheap and do the job just as good as anything else that you are going to find in a store.

The only negative with the BRP orange fenders is the rear one drags water into the footwell. I always remove the rear one after leaving the jetty, the front one is ok left on. Maybe Straight can report whether her idea does the same? You're the guinea pig with this idea!!

Straightbangin said:

Piece of pool noodle and bamboo barbecue skewer ( that is wider on the top) $2
Match pool noodle to your ski if you want it to look slightly fancier LMAO

Click to expand...

This is what I'd go with. I might trim down the skewer some so that I don't end up stabbing myself by accident with it if I fall or something.

Straightbangin said:

LoL. These are 9.5" with a wide paddle top

I'm having a hard time finding more.

Click to expand...

The wide top makes more sense. I thought they were more pointed at either end.

Neptune said:

This is what I'd go with. I might trim down the skewer some so that I don't end up stabbing myself by accident with it if I fall or something.

Click to expand...

Along with trimming it, you might want to consider adding some rubber grommet to the end to make it even better in case you hit it. I'm sure you could find some rubber grommet or something like it at the hardware store.

good idea just replace the skewer with a zip clip no safety issue and will hold on better

Neptune said:

This is what I'd go with. I might trim down the skewer some so that I don't end up stabbing myself by accident with it if I fall or something.

Click to expand...

Where did you get those metal washers, xdrian? How many do i need and Whats the price for it?

Patrick the metal washers are aluminium I made them they take about 5 to 7 minutes each to make and you will need about 34 to do all of them but you can buy on ebay if you want

Patrick Throndsen said:

Where did you get those metal washers, xdrian? How many do i need and Whats the price for it?

Click to expand...

Neptune said:

This is what I'd go with. I might trim down the skewer some so that I don't end up stabbing myself by accident with it if I fall or something.

Click to expand...

Yeah it would suck if you got stabbed in the eye or something simular...

Ok,thanks xdrian


Sent from my iPhone using Tapatalk