SeaDoo Spark Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 2016 spark. it has been sitting for close to a year with the battery removed. I need to replace the pto(?) (gears in engine that drive the drive shaft) and have not had time to do it. I went out today and reinstalled the battery (full charge). After 15 minutes of cranking it it finally started and ran good (just ran it a new seconds). However, I was confused soon as I put the battery in because I thought that when I connected the key it would beep 2 or 3 times, it did nothing. I also thought the screen came on, also nothing. Any thoughts as to why it does not beep when the key is attached and why the screen does not turn on?
 

·
Registered
Joined
·
6 Posts
I am having the same challenge. one of mine will no screen and no beep and just go right to start up with out any display. I am wondering if it is tied to the display or if it is the ecm computer. I posted yesterday hoping to find out more but have not found out anything yet. Let me know if you have found out anything or how you fixed this.
Thanks
 
1 - 3 of 3 Posts
Top