SeaDoo Spark Forum banner
1 - 3 of 3 Posts

· Registered
6 Posts
Discussion Starter · #1 ·
Hey all ,I need some sage advice . The wife sucked up some crud and broke the wear ring on her machine. I have replaced it before so that isn't the problem. At about 11 o'clock there is a plastic tube that comes out and feeds into the impeller housing . It goes to a plastic nut on the impellar section . That tube has broken on mine . So I have a gap between the ski and the housing and an open tube .

So can I just seal the hole with something or is important for other things ?
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.