SeaDoo Spark Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Need help. 3 up Spark with iBr -- When changing out wear ring - as I was pulling off pump housing off back of PWC - small metallic cylindrical spacer drop out. Not sure where it goes?
Any ideas -- only place that seems reasonable is around 1030-11 o'clock position where black tube enters

Thanks
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top