DIY mats
1 - 20 of 23 Posts
Joined
·
24 Posts
Looks awesome! Ditto on the templates.
Joined
·
184 Posts
Is that just the foot wells and knee pads? I have 3 ups and would like the back platform too?
Edit to add: Are these like stickers or do you have to use a glue?
Yep, my phone sent this...
Joined
·
733 Posts
how thick are they?
Joined
·
184 Posts
Joined
·
437 Posts
I would like to knwo as well
Joined
·
142 Posts
I purchased a roll of cut diamond from hydro turf. I like the cut turf better then the molded because its has more grip and is softer. I glued mine down. I dont like the stick on stuff. I use the same glue that they use to glue down counter tops.
Sent from my SAMSUNG-SGH-I537 using Tapatalk
Sent from my SAMSUNG-SGH-I537 using Tapatalk
Joined
·
733 Posts
ok, I'm interested
Joined
·
199 Posts
i have the 3up extened part for u rampage. if you need it .
Joined
·
1 Posts
Whats the glue for these?
1 - 20 of 23 Posts
Join the discussion
Recommended Reading
-
Major Hull Repair < $100
Sea-doo Spark How To & DIYI have 4 sparks and we ride them like we stole them. Sometimes when a rookie is aboard bad things happen. Last week a rock on shore met the hill and knocked a 3" hole just below the trailer ring. My first and only disclaimer was to fix it cheap and strong and get back on the water. The...- 3
- 4K
-
The Ultimate Hull Crack Repair Thread
Sea-doo Spark How To & DIYI got a crack in the hull from my Spark hitting my other ski broadside. The crack is about 2ft long, and 1/4" wide at its largest spot. The 1/4" wide part is partially due to the impact pushing part of the plastic under the plastic next to it. The repair was a combination of a plastic welder...- 5
- 7K
-
Swaping to Red/Yellow Handle bars?
Sea-doo Spark How To & DIYJust purchased a Spark Trixx in the Pear/Jalapeno combo and switched the pear pannels to black (photo attached) Was looking at swapping out the white handle bar for the yellow bar. And putting the red handle grips on! Has anyone done this swap or know where there is a step by step instructions?- 2
- 374
-
Davecat23 · updated
-
How to change impeller and wear ring
Sea-doo Spark How To & DIYHere is how i changed my stock impeller and wear ring to a solas 12/17 and a riva racing ss ring. If you dont have ibr, this will be alot easier. 1. remove the bolt with nut that secures the ibr rod to the ibr bucket. 2. Remove the 2 bolts holding the bucket to the venturi. Right bolt: Left...- 12
- 20K
-
Patrick · updated
-
A spare hull repair piece page ?
Sea-doo Spark How To & DIYSince there a ton of sparks out there and it seems the vast majority still do not realize most damage no matter how nasty can be repaired so they are parting out or buying new hulls I would like to start a thread that has all broken hulls/pieces in a database for those of us who repair them all...- 0
- 307
Join now to ask and comment!