SeaDoo Spark Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
ive searched the forums and havent really seen an answer...


2021 spark 90hp with ibr, i installed the extended vts and once the install was complete, the vts icon wasnt showing on the dash display, up and down buttons did nothing, and i couldnt enter the ibr override mode. this is my fourth spark ive installed the vts kit and the first three i had no issue. i double checked to make sure the wires were fully seating into the harness and in the correct positon and the vts module(brain?) was installed in its correct spot. the spark fired up an ran properly with the kit installed, but again, no vts at all. from the sparks point of view, it was never installed.

has anyone ran into this issue? is it possible the vts kit was a bad on out of the box? it was ordered through amazon so a replacement kit is on its way and hopefully this one works as it should
 
1 - 2 of 2 Posts
Top