SeaDoo Spark Forum banner
1 - 13 of 13 Posts

·
Premium Member
Joined
·
768 Posts
If you a refering to a hole drilled, that would not be a good idea since it would drain in the engine compartment. after I wash the ski I just take a towel and soak up the water there, clean of the extinguisher and put it back.
 

·
Registered
Joined
·
20 Posts
Discussion Starter · #5 ·
What I'll do is install a small fitting into the bottom corner, run a 6mm hose to side of the ski and let it empty out of a tell tail fitting we use in our pole skis, is neat and will drain into the foot well, prob solved. I know its petty, and I'm lucky cos after I wash mine I tow it up my drive to my shed and all the footwellls empty up the hill
 

·
Registered
Joined
·
59 Posts
What I'll do is install a small fitting into the bottom corner, run a 6mm hose to side of the ski and let it empty out of a tell tail fitting we use in our pole skis, is neat and will drain into the foot well, prob solved. I know its petty, and I'm lucky cos after I wash mine I tow it up my drive to my shed and all the footwellls empty up the hill
sounds good to me, let us know when you do that, even some pictures of it would be great.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top