SeaDoo Spark Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter #1
Has anyone on here installed manual reverse?
 

·
Registered
Joined
·
337 Posts
Has anyone on here installed manual reverse?
I'm not sure, seems many folks here went with IBR. Have you not?

I was reading on another forum people were not pleased trying to install manunal reverse as it seems the easiest/most convenient place to mount is where your trim control is and no body wants that.

Could of just been the thread however...
 

·
Registered
Joined
·
53 Posts
Discussion Starter #4
got 2 sparks coming without IBR, looking at installing reverse but would like some pics for the install, dealer quoted 4-5 hour install time at $110 per hour which means I should have got the IBR. so I'm thinking of doing it myself
 

·
Registered
Joined
·
53 Posts
Discussion Starter #7
Btmg. Spark has no trim. It's also a lever and cable not electrical
Like ibr.
I'll talk to the dealer when I go pick up the skis and check it out
 

·
Registered
Joined
·
430 Posts
if anyone ends up doing it themselves post up some photos and a quick DIY

I"m sure it'll help others in the long run
 

·
Registered
Joined
·
53 Posts
Discussion Starter #10
Don't count on me doing it, forecast is for 4 inches of snow this weekend , by the way this is going I won't get out on the water til august!
 

·
Registered
Joined
·
2 Posts
Has anyone actually tried installing the reverse kit yet? I am in the process of installing it and I am about to scream .. I am currently stuck... Has anyone had any issues with the spring and getting it installed correctly without it wanting to break completely off the bucket!? I have everything else pretty much done, just being held up by this dang spring.. Any ideas??
 
1 - 14 of 14 Posts
Top