SeaDoo Spark Forum banner

polypropylene-blend / plastic hull a problem?

8K views 8 replies 5 participants last post by  srsbz 
#1 ·
Do you think the plastic hull will cause any durability problems with the Spark?

I know plastics have gone a long way in the past century but it still makes me question if it's going to be a good idea. I think Sea Doo should do some torture tests to show people.
 
Discussion starter · #5 ·
There is a rubber gasket seal between the 2 halves of the hull, Leakage won't be a problem. The Hull should be fine, and much cheaper to replace than Fiberglass was.
For example , if you run head-on into a dock and need a new front end bumper piece, it will cost you like 39.00 for a replacement.
39$ for a hull?!

geez...

I'm just wondering if fiberglass is strong than the poly blend plstic.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top