SeaDoo Spark Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
306 Posts
Discussion Starter #1
Today I put tapes on the alarm. Sounds is way better now. Was wayyyy to loud. You should try it. Tape needs to cover the hole of the speaker. I used masking tape for painting.

Sent from my SGH-I337M using Tapatalk
 

·
Registered
Joined
·
43 Posts
Where is the alarm located? I've been wanting to put a muzzle on that foghorn of a warning chime.
 

·
Registered
Joined
·
165 Posts
I don't mind the little chirp on start up, but holy sweet **** "I KNOW YOU'RE LOW ON FUEL, DON'T SCREAM IT EVERY 5 MIN"
 

·
Registered
Joined
·
21 Posts
The alarm speaker is on the underneath of the lcd dash.
Look in through the safety cover at the bottom of dash and you will see a round part about 40 mm round with a 10mm hole in middle of it.
If you tape over it then it can barely be heard. I can not see how you would glue it because it's upside down.

Maybe glue a piece of foam over it so it's not blocked completely.




Sent from my SM-N910G using Tapatalk
 

·
Registered
Joined
·
306 Posts
Discussion Starter #11
It will never get off. No water goes there. Make a small hole on the tape if you want to hear it.

Sent from my SGH-I337M using Tapatalk
 

·
Registered
Joined
·
21 Posts
I used electrical tape..
I think painters tape or masking tape will dry over time and become brittle.
If you got duct tape I would use it.




Sent from my SM-N910G using Tapatalk
 
1 - 12 of 12 Posts
Top