SeaDoo Spark Forum banner

Reverse without ibr?

7345 Views 4 Replies 5 Participants Last post by  [email protected]
Does anyone have manual reverse on there spark? I didn't get ibr because I wanted to keep upfront costs low but Maybe next winter I can install a manual reverse kit as a project. Do you know how hard it is too install and will it fit 60 hp 2 up models?
1 - 5 of 5 Posts
It will fit 2 up and 3up 60 and 90hp
Motivated tech can have it installed in 3-4hrs.
Does anyone have manual reverse on there spark? I didn't get ibr because I wanted to keep upfront costs low but Maybe next winter I can install a manual reverse kit as a project. Do you know how hard it is too install and will it fit 60 hp 2 up models?
I had it on my 2 up last year, doesn't matter what engine you have. works pretty good, it isn't as convenient as IBR but better than not having reverse at all. I installed it myself, I think it took me 4-5 hours taking my time reading through the instructions a few times. first thing I did was organize all the hardware by type and size so just had to grab everything for the next step and it made things go pretty easy, probally take half the time if I had to do it again. if you are going to attempt it your self make sure you pay attention to running the cable in the hull, especially where you run the cable by the engine mounts and toward the rear of the hull. The reverse is hard to activate out of the water, gets better when you are in the water with the engine running.
  • Like
Reactions: 1
That install time is not bad at all, nice little weekend job to do.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top