SeaDoo Spark Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Does anyone know if you must 'pop the top' to remove the Riding Plate? I have two Sparks with IBR and one of them needs a flush kit installed. I can't seem to figure out how to install the flush kit without removing the Riding Plate. I've seen other posts on the forum saying that it can be done in as little as 15 minutes but I just can't see how that's possible with IBR and the Riding Plate installed.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top