SeaDoo Spark Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hey guys one of my friends sucked up some rocks in havasu. The rock got stuck on the propeller. So I'm changing propeller and wear ring. But I also noticed my drive shaft has a ding on it. Does anyone know how or have instruction on how to remove drive shaft. I've searched for videos and can't find anything. Any help would be appreciated thanks in advance
 

·
Registered
Joined
·
6 Posts
I don't think you would need to replace the driveshaft if it is just 'dinged'. Does it seem bent, or have a wobble to it when you spin it?
 

·
Registered
Joined
·
5 Posts
There’s videos on YouTube about removing the driveshaft. Basically have to take the upper deck off to access it, there’s a rubber boot at the end of the motor that has to come off, then pull the shaft back toward the pump. Be careful of the seals by the PTO..
 
1 - 3 of 3 Posts
Top