SeaDoo Spark Forum banner
1 - 20 of 23 Posts

·
Registered
Joined
·
52 Posts
Page 50 in the operators manual. Safety Equipment Kit Storage Compartment. Just what are we going to bail anyways? Guess I'll have to carry a 30 torx to lift the deck so I can scoop some water.

FYI; Yello Attwood Bailer 11831 doesn't fit
 

·
Registered
Joined
·
1,027 Posts
You can get the full workshop manual here Seadoo Spark Service Workshop Manual
Wow, great "investment" $15, can't be beat.




What it features:




Covers all models including 2Up, 3Up and HO

Topics covered:

  • Steering and OTAS Systems
  • Starting System
  • Jet Pump
  • Fuel Injection EFI
  • Multifunction Gauge
  • Fuel Injection EFI
  • Power Distribution and Grounds
  • Charging system
  • Technical specifications
  • Wiring Diagram Information
  • Wiring Diagram 1
  • Wiring Diagram 2
  • Drive Shaft
  • Connector Information
  • Hull
  • Air intake system
  • Timing Chain
  • Lubrication System
  • Magneto and Starter
  • Cylinder Head
  • Engine removal and installation
  • Special procedures
  • Fuel Tank and Fuel Pump
  • Preseason Preparation
  • Exhaust System
  • Cooling System
  • Intelligent Throttle Control (iTC)
  • 2014 Sea-Doo SPARK DTC Table
  • Diagnostic and Fault Codes
  • Ignition system
  • Communication Tools and BUDS
  • Cylinder Block
  • Controller Area Network (CAN)
  • iControl System
  • Engine Management System
  • Storage procedure
  • Periodic Maintenance Procedures
  • Periodic Maintenance Schedule
 
1 - 20 of 23 Posts
Top