SeaDoo Spark Forum banner
1 - 2 of 2 Posts

· Registered
23 Posts
Discussion Starter · #1 ·
I am new to this so maybe some of you know this already, but it worked out so well that I thought I would share it.

I have the Seadoo Move 1 galavanized ext. trailer. It came with a blue bow roller on the winch that did not fit the Spark at all. Every time I would drive to the lake I would center the roller, but when I got to my destination the Spark had moved either to the right or left. Thought I was not tightening the winch enough so on my next trip I tighten it a bit more. Got to my destination and guess what, the Spark had moved again and the side of the roller looked smash down a bit. The metal bracket was less then half an inch away from the Spark.
Thought I would replace the roller with one that fit the Spark better and found a bow stop instead. Installed in minutes and it work perfectly, it HUGS the bow of the Spark and keeps it totally still, even after a long drive. It looks good and I am sure it is a safer option. Pictures below.


1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.