SeaDoo Spark Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I recently performed a full tune-up following Mohawk Dave's youtube videos to the letter. After completion, I started the ski and it was a little difficult to start, however, it did turn over and was smoking quite a bit. This is the first time I've done this but did it following his directions exactly as he did them. I only started the spark for about 20 seconds without water and shut it off. Did that a couple more times hoping the oil was just burning off but it keeps smoking quite heavily. Any thoughts? Too much oil? solutions? I used all recommended OEM oil, filter, and plugs. Then sprayed the motor with xps lubricant as he suggested. Thanks in advance for any help!
 
1 - 1 of 1 Posts
Top