SeaDoo Spark Forum banner

Spark Manual Reverse

2820 Views 4 Replies 3 Participants Last post by  Luis Quinones
I just got done installing the Manual Reverse Kit and everything went good. The one thing I noticed is when pulling the handle up to engage reverse it is really a lot of tension. It may be the spring is causing a lot of it but wonder if this is normal. anyone else have any recomendations?
1 - 5 of 5 Posts
Hi, i have one Spark with manual revers and it is very hard.. Its installed by the dealer.

Its the same with my 2 friends. They have the same tension that i got (and probably you).
Someone told me that it may be easier in the water? is this true?
If anything I would think it would be harder with thrust pushing against it.


Sent from my iPhone using Tapatalk
If anything I would think it would be harder with thrust pushing against it.


Sent from my iPhone using Tapatalk
I took it out to test it yesterday and to my surprise it is easier to engage and disengage in the water. But then I found out that My wear ring may need to be replaced.:|
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top