SeaDoo Spark Forum banner
1 - 1 of 1 Posts

· Registered
115 Posts
Discussion Starter · #1 ·
I flushed the spark today, suddenly it just stopped...? Engine was completely cold and started up fine. I just changed the oil and it's a little low on the dipstick, but i haven't got any low oil messages on the display. I haven't really driven it yet, but i was on the water running for a couple minutes earlier that day. So, what happened was: i started it up, ran it for 30 sec at idle, and then revved it slowly and then it stopped. Rushed to turn of the water, so i don't think i got any water in the engine, but i tried to start it to make sure. And then it just started normally? Filled it up with oil and then it started normal again?
So, why did it just stop? Some low oil safety thing, or...?

Sent from my iPhone using Tapatalk
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.