SeaDoo Spark Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
My 2017 Spark sits on a lift. In the evening yesterday, I walked out on the dock and the bilge was running. It wasn't running earlier that day and it hasn't been used. The bilge just started running sometime in the late afternoon.

After an hour or so, it was still running so I pulled the 3A fuse.

There is no water in it.

Two questions:
Why this would just start running and not shut off?
What do I check to fix this? I don't think they have a float

EddieRock
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #2 ·
I think there was one of two issues going on here. Either the battery was going bad and caused some strange electrical issue where the bilge started going -OR- something got stuck in the bilge and caused the float to go up. The latter seems like the problem but the ski wasn't used for a few weeks and the bilge to just start doesn't make sense to me.

I ended up replacing the battery. I then ran it for a while on the lake and made sure the battery was good. I then put the 3 amp fuse back in and the bilge didn't run again. So I don't 100% have a cause for this issue.
 
1 - 2 of 2 Posts
Top