SeaDoo Spark Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I plan on building a stand to store my Spark on for the winter in the garage.
Is putting the two supports under the metal chassis (13'' apart) the way to go or should they be at the same distance as on my trailer(wider).
To me, that would make the most sense since the motor is mounted there.
 

·
Registered
Joined
·
274 Posts
I plan on building a stand to store my Spark on for the winter in the garage.
Is putting the two supports under the metal chassis (13'' apart) the way to go or should they be at the same distance as on my trailer(wider).
To me, that would make the most sense since the motor is mounted there.
if you support it at the metal engine supports i would be afraid of dragging and marking the metal, not sure how thick the heat exchanger it self is if it would be prone to denting etc. but i would think if you support it on the hull itself it will slide easier on and off the stand and it would be more stable on the stand if it were where your bunks were mounted on your trailer...just my 2 cents
 
1 - 2 of 2 Posts
Top